Hitachi Content Platform S Series User Manual

5. Enter 1 .
Information about the S Series Node network interfaces appears. The
network interface for the management network is eth1.
6. Make a note of the inet and netmask values for eth1.
7. Press Enter to return to the Diagnostics Menu.
8. Enter q to exit the Diagnostics Menu.
9. Do either of these:
¡
For an HCP S10 Node, disconnect your laptop computer from the
server module.
¡
For an S30 Node, disconnect the VGAmonitor and keyboard from
the server module.
Reconfiguring your laptop computer for SSH access
To reconfigure your laptop computer for SSHaccess to an S Series Node
server module:
1. Connect the CAT6 Ethernet cable to the Ethernet port on the laptop
computer and to the management port on the server module.
On an S10 Node, the management port is the third Ethernet port from
the left on the back of the server module.
12
Chapter 2: Preparing for HCP S Series Node refurbishment
HCP S Series Node Refurbishment
Installing and using PuTTY on the laptop computer

Hitachi Content Platform S Series Specifications

General

Brand	Hitachi
Model	Content Platform S Series
Category	Server
Language	English