2. While pressing down the blue tabs on both sides of the top of the cover,
pull the cover one-half inch back.
3. Lift the cover off the server module.
Step 17f: Remove the riser card from the server module
The four-port Ethernet PCI card, two-port Ethernet SFP+ PCI card, and two
SASPCIcards are attached to the riser card in the server module. To
remove the PCIcards from the server module, you need to take the riser
card out of the module.
Chapter 4: Refurbishing an HCP S30 Node
89
HCP S Series Node Refurbishment
Step 17: Unrack, disassemble, and pack the server modules
To Next Page
Loading...
Need help?
General