HP ProLiant DL580 Generation 2 User Manual

Connectors, LEDs, and Switches
Enabling ROMPaq Disaster Recovery Mode
A corrupted system ROM requires you to recreate the ROM BIOS by using the ROM flash
utility. This can be accomplished only when the system is in disaster recovery mode. Set
configuration switches 1, 4, 5, and 6 on the system maintenance switch block to on to enable
disaster recovery mode.
IMPORTANT: Before enabling ROMPaq disaster recovery mode, refer to the HP Servers
Troubleshooting Guide for complete instructions on disaster recovery.
System ID Switch (SW7)
Figure 4-18 and Table 4-21 identify the system ID switch location and settings.
Figure 4-18: System ID switch (SW7)
Table 4-21: System ID Switch (SW7)
Position Default Function Description Settings
1 through 3 Chassis ID Used to allow 8
ID combinations,
if used as
another system.
4-26 HP ProLiant DL580 Generation 2 Server Maintenance and Service Guide

HP ProLiant DL580 Generation 2 Specifications

General

Brand	HP
Model	ProLiant DL580 Generation 2
Category	Server
Language	English