2 Product Description
This instruction manual describes the KEB F6 ELEVATOR DRIVE. The F6 device series
applies to drive controllers, which are optimized for operation at synchronous and
asynchronous motors. The F6 can be extended with a safety module for the use in
safety-oriented applications. It can be operated with a fieldbus module at different
fieldbus systems. The control board has a system comprehensive operating concept.
The F6 meets the requirements of the Low-Voltage Directive. The harmonized standards
of the series EN 61800-5-1 for drive controller were used.
The F6 is a product of limited availability in accordance with EN 61800-3. This product
may cause radio interference in residential areas. In this case the operator may need to
take corresponding measures.
The Machine Directive, EMC directive, Low Voltage Directive and other guidelines and
regulations must be observed depending on the version.
2.1 Specified Application
The F6 Elevator Drive serves exclusively for the control and regulation of three-phase
motors. It is intended for the installation into elevator control systems.
Technical data and information for connection conditions shall be taken from the
nameplate and instructions for use and must be strictly observed.
The used semiconductors and components of KEB America, Inc. are developed and
dimensioned for the use in elevator systems.
Ensure reliability and security of unit!
The reliability and security of the unit must be ensured by the responsible
party. The unit shall be utilized under the designated conditions and safety
measures to ensure the essential functionality.
2.1.1 Residual Risks
Despite intended use, the drive converter can produce unexpected operating conditions
in case of error, with wrong parameterization, by faulty connection or unprofessional
interventions and repairs. These can be:
• Wrong direction of rotation
• Motor speed is too high
• Motor is running into limitation
• Motor can be under voltage even in standstill
• Automatic start
2.2 Unintended Use
The operation of other electric devices is prohibited and can lead to the destruction of the
devices. The operation of our products outside the indicated limit values of the technical
data leads to the loss of any liability claims.
To Next Page
Loading...
Need help?
General