6.3 Parameter Adjustments
This section shows how to adjust parameters on the F6. There are two methods to adjust
the parameters on the LCD operator:
1. Using the UP and DOWN buttons to change the parameter.
2. Using the NUM function and changing the number digit-by-digit, left to right.
6.3.1 Up and Down Buttons
Follow the steps below to adjust the parameters using this method:
1. Select the parameter to be changed and press ENTER.
2. Press ENTER again to go into Edit Mode.
3. Press UP or DOWN buttons until the desired number is displayed.
4. Press ENTER to save.
6.3.2 NUM Function
The NUM function allows you to make extensive and exact changes quicker. This method
requires changing digits left to right until the desired number is on display, instead of
scrolling. For this method, go to Edit Mode as instructed in the section above and follow
the steps below:
• In Edit Mode press F4.
• Press the UP or DOWN buttons until the leftmost digit is on display.
• Press F4 >> to move to add another digit.
• Press the UP or DOWN arrow to change the value.
• Press F4 and change the values until your desired value is on the display.
• Press ENTER to save.
To Next Page
Loading...
Need help?
General