Komatsu 930E-2 User Manual

Monitoring Input Signals
This procedure can be used to monitor the current
input signals to the payload meter.
1. Press and hold the LIGHT/INC and MODE
switches until "CHEC" is flashing.
2. Press and hold the CAL/CLR and TOTAL/SFT
switches until "S.CHE" is flashing.
3. Press the CAL/CLR switch to cycle through the
following information :
4. Press the MODE switch once and "CHEC" will
flash.
5. Press the MODE switch once and the meter will
return to normal operation.
Service Check Mode
1. Press and hold the LIGHT/INC and MODE
switches until "CHEC" is flashing.
2. Press and hold the LIGHT/INC switch until "ALL0"
is flashing. "A.FUL" may also be displayed.
3. Press the LIGHT/INC switch to cycle through the
following data. The sequence repeats.
4. Press MODE once and "CHEC" will flash on the
display.
5. Press MODE once and the meter will return to
normal operation.
C1 Mechanical Trucks
C1:oo - Shift Selector in "N"
C1:-- - Shift Selector
not in "N"
C1 Electric Trucks
C1:oo - Brake Lock On
C1:-- - Brake Lock Off
C2 Body Up
C2:oo - Body Down
C2:-- - Body Up
C3 Engine Oil Pressure
C3:oo - Engine Run
C3:-- - Engine Stopped
C4 Alternator R Terminal
C4:oo -Alternator Charging
C4:-- - Alternator Stopped
C5 Analog 1 - Not Used
C6 Analog 2 - Not Used
C7 Digital 1 - Not Used
C8 Digital 2 - Not Used
C9 Speed Vehicle Speed
C10
Travel Distance -
under the current
loaded or empty state
xx.xx Miles
C11
Current Status
Note:
Sample values are
shown.
03:01 - Empty Stopped
01:02 - Empty Traveling
06:03 - Loading
02:04 - Loaded Traveling
04:05 - Loaded Stopped
05:06 - Dumping
C12(a)* Time Empty Travel S1:xx - Minutes*10
C12(b) Time Empty Stopped S2:xx - Minutes*10
C12(c) Time Loaded Travel S3:xx - Minutes*10
C12(d) Time Loaded Stop S4:xx - Minutes*10
C12(e) Time Dumping S5:xx - Minutes*10
C12(f) Time Loading S6:xx - Minutes*10
* After 9.9 minutes, "S1:--" will be displayed.
Item and Description Units
1. Current Time Hours:Minutes
2. Pressure Front Left Psi
3. Pressure Front Right Psi
4. Pressure Rear Left Psi
5. Pressure Rear Right Psi
6. Front Weight Tons
7. Rear Weight Tons
8. Degree of Incline
± ° N o s e U p
Positive
9. Incline Factor - Front Axle
10. Incline Factor - Rear Axle
11. Link Factor - Front Axle
12. Link Factor - Rear Axle
13. Calibration Weight Tons
14. Gt - Trimmer Gain
15. Current Load Tons
16. Backup Battery Voltage Volts
M20-22 Payload Meter II M20007 10/00

Komatsu 930E-2 Specifications

General

Brand	Komatsu
Model	930E-2
Category	Trucks
Language	English