Lenze i55 Series User Manual

9.11 POWERLINK
POWERLINK is a real-me capable eldbus system based on Ethernet.
•
Detailed informaon on POWERLINK can be found on the web page of the Ethernet POW-
ERLINK Standardizaon Group (EPSG): hp://www.ethernet-powerlink.org
•
Informaon about the dimensioning of a POWERLINK network can be found in the cong-
uraon document for the inverter.
Precondions
•
Control unit (CU) of the inverter is provided with POWERLINK.
9.11.1 Introducon
The inverter is implemented as a controlled node (CN) into a POWERLINK network. Thus, it
only may respond to poll-request messages of a managing node (MN). For typical topologies
see the secon "POWERLINK" in the "Electrical installaon" chapter. ^ 70
Features
•
The network opon can both be supplied internally by the standard device and externally
by a separate voltage source.
•
Real me Ethernet with the Ethernet POWERLINK V2 communicaon prole for Moon
and general applicaons
•
A line topology can be set up by the integrated 2-port hub.
•
Supported funconalies: POWERLINK CN
•
Very short CN response mes for opmum network performance
•
Access to all inverter parameters
The following is not supported:
•
Firmware download via POWERLINK
•
PDO crosslinks for the managing node or the controlled node for seng up systems with
"distributed intelligence"
Conguring the network
POWERLINK
Introducon
396

Lenze i55 Series Specifications

General

Brand	Lenze
Model	i55 Series
Category	Inverter
Language	English