Lenze i55 Series User Manual

16.1.2 Keypad parameterisaon mode
In the parameterisaon mode of the keypad you can have actual values of the inverter dis-
played for purposes of diagnoscs and change sengs of the inverter.
Use the to change from operang mode to the parameterisaon mode.
•
If a write access protecon is acve for the inverter, the keypad automacally displays a
log-in when changing to the parameterisaon mode. You can either skip the log-in and
thus keep the access protecon acve or remove it temporarily by entering a valid PIN.
4Write access protecon ^ 450
•
Use the to return to the operang mode.
16.1.2.1 Parameter groups
In order to provide for quick access, all parameters of the inverter are divided into dierent
groups according to their funcon.
•
Group 0 contains the congurable "Favorites". In the default seng these are the most
common parameters for the soluon of typical applicaons. 4Favorites ^ 459
•
Based on the hundreds digit of the display code (Pxxx) you can quickly see in which group
the parameter is to be found on the keypad:
Parameter Group/name Descripon
P1xx Group 1 - Diagnoscs Diagnosc/display parameters for displaying device-internal process factors, current
actual values, and status messages.
4Diagnoscs parameter ^ 109
P2xx Group 2 - Basic seng Seng of the mains voltage, selecon of the control and setpoint source, starng and
stopping performance, frequency limits and ramp mes.
4Basic seng ^ 143
P3xx Group 3 - Motor control Conguraon of the motor and motor control
4Motor control ^ 163
P4xx Group 4 - I/O seng Funcon assignment and conguraon of the inputs and outputs
4Flexible I/O conguraon ^ 525
P5xx Group 5 - Network seng Conguraon of the network (if available)
4Conguring the network ^ 226
P6xx Group 6 - Process controller Conguraon of the process controller
4Conguring the process controller ^ 407
P7xx Group 7 - Addional funcons Parameterisable addional funcons
4Addional funcons ^ 417
P8xx Group 8 - Sequencer The "sequencer" funcon serves to dene a programmed sequence of speed setpoints,
PID setpoints or torque setpoints for the motor control. Switching to the next setpoint
can be executed in a me-based or event-based manner.
4Sequencer ^ 504
Appendix
Operate and parameterise the inverter with keypad
Keypad parameterisaon mode
635

Lenze i55 Series Specifications

General

Brand	Lenze
Model	i55 Series
Category	Inverter
Language	English