112 Matrix SETU ATA211 V1 System Manual
• If this Routing type is set, the ATA will process the call as per the 'Called party number table' and route the
call to the destination route selected by the 'called party number Table'.
• Please refer chapter “Called Party Number Table” in Configuring SETU ATA211.
Fixed Destination Number:
• Program the 'Fixed Destination Number' in this field if the Routing Option is selected such that call is to be
routed to the fixed destination number.
• Use maximum 16 digits with Blank, 0~9, * & #.
Default = Blank.
Ring Timer:
• It is the time duration for which 'ring' will be played on FXS for the IC call.
• Program the suitable value of 'Ring timer' from the range of 01 to 99 seconds.
Default = 45.
Use 183 Session Progress to connect media?
• This feature allows the system to send the SIP message; either '183 Session Progress' or '200 OK' when
the system answers the IC call on the SIP account (viz. when caller gets dial tone) and speech is to be
established.
• The feature is applicable for following IC call routing options in the system:
• Route to fixed destination number through FXO
• Route to FXS. If not answered within ring timer, route to fixed destination number through FXO
• Answer the call and connect to FXO
• Route to FXS. If not answered within ring timer, answers the call and connect to FXO
• Collect number and route to FXS
• Collect number and route to FXO
• Route as per called party number
• Select 'Yes' if you want the system to send '183 Session Progress'.
• Select 'No' if you want the system to send '200 OK'.
Default = Yes.
Caller Authentication
Authentication Type:
• This feature is required when the incoming calls on SIP or FXS or FXO port is to be allowed only from
specific callers. For calls on SIP from SIP device, the feature Digest Authentication is required to be
configured and for FXS/FXO/SIP, PIN Authentication is required to be configured.
• Select the type of Caller Authentication (Authentication on SIP Account), from options:
• None
•PIN
• Digest
Default = None.
• If 'None' is selected, Caller Authentication on SIP Account will be disabled.
• The option 'PIN' will be applicable, only if the 'Routing Options' is configured for following Routing Type for
IC call on SIP:
• 'Collect number and route to FXS' OR
• 'Collect number and route to FXO'. Refer chapter “PIN Authentication”.
• If 'Digest' is selected, the Authentication will be enabled for all IC call on SIP account. Refer chapter
“Digest Authentication” for configuring the Digest Authentication Table.
To Next Page
Loading...
Need help?
General
