Matrix SETU ATA211 V1 System Manual 99
Peer-to-Peer Call Table
• A call made between two IP clients without the intervention of a Proxy Server is defined as Peer-to-Peer
Call.
• If the SIP Account which is used for routing logic of the FXS or FXO port is programmed with Registrar
Server Address, ATA211 will consider it as SIP Proxy trunk. If the address is not programmed, ATA211 will
consider it as SIP Non-Proxy (P2P) trunk.
• Refer topic “Call Features” in chapter 'Using SETU ATA211' for more information about working of P2P
feature.
• Refer topic “Making Calls” in chapter 'Using SETU ATA211' for more information about making P2P call.
How to program?
Open the Web Jeeves and click on 'Peer to Peer Call Table' link. (Only Admin can access this Webpage). The Web
page will be as shown below:
Total 500 entries can be programmed in the Peer-to-Peer table. Each entry should be programmed using following
parameters viz. Name, Number and Destination Address.
• Name: The 'Name' is configured to identify the specific contact. Enter maximum of 16 characters. The
ASCII characters are allowed. By default it is blank.
To Next Page
Loading...
Need help?
General
