Matrix SETU ATA211 V1 System Manual 15
CHAPTER 3
Getting Started
Protecting SETU ATA211
You should take following measures to protect your SETU ATA211.
Installation Precautions:
• Do not install the system in direct sunlight and the place where there is excessive cold or humid
atmosphere.
• Do not install the system where sulfuric gases are produced and in areas where there are thermal springs
because it may damage the equipment.
• Do not install the system at the places where shocks or vibrations are frequent or strong.
• Do not install the system at dusty places or places where it may come in direct contact with oil or water.
• The system should be installed at the place where enough open space is there for ventilation.
Safety Instructions:
You should always take basic safety precautions to reduce the risk of fire, electric shock and injury to the system as
well as the person using it. Follow the steps given below:
• Read and understand all the instructions given in the manual properly.
• Unplug the product from the wall outlet before cleaning and do not use liquid cleaners. Use only dry and
soft cloth.
• Do not use the product near water i.e. near a bath-tub, kitchen sink or near a swimming pool.
• Do not open the system in power ON condition.
• Do not place the product at the place from where it can fall and serious damage may be caused to the
product.
• Interfacing cables should not touch the exposed power line cable.
• The product should be operated with proper power voltage supply.
• Do not place the product where power cord can be misused.
• Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
• To reduce the risk of electric shock or damage to the system, take the product to the qualified serviceman
when some repair work or servicing is required. Removing covers or opening the system or incorrect
reassembly may cause electric shock when used subsequently.
Unplug the system from the wall outlet and contact the qualified service personnel under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If liquid has been spilled into the product.
• If the product has been exposed to rain or water.
To Next Page
Loading...
Need help?
General
