8 Matrix SETU ATA211 V1 System Manual
Programming Options
• SETU ATA211 gives flexibility to configure its parameters either using Conventional Phone Instrument or
computer. ATA211 supports embedded Web server (http based) so that the parameters can be configured
using GUI based special software called Web Jeeves.
• You will be able to configure only limited Parameters and features through phone. Please refer appendices
“System Commands”.
• Using computer, you can configure all the parameters of ATA211. To configure the parameters using
computer, configure the IP address and subnet mask of LAN/WAN port of ATA211 using phone and open
the Web Jeeves.
Configuring using Phone
You can configure the IP Address and Subnet Mask of LAN/WAN port and Connection Type of ATA211 using
Conventional Phone Instrument as explained below:
1. Pick up the handset of Analog Phone connected to ATA211.
2. Dial the programming access code #19 followed by the Admin Password (default is 1234). OR dial the
access code #18 followed by User Password (default is 1234). You will get programming tone.
3. To change the connection type of the WAN port, viz Static, DHCP or PPPoE, enter command:
15<Code>#*. To enable/disable 'L2 VLAN/CoS' on WAN port, enter command: 16<Code>#*. Where,
code is 0 for disable and 1 for enable.
4. Enter LAN IP address using the command: 12<LAN IP Address>#*. For example to enter IP address
192.168.1.120, enter the command 12<192168001120>#*.
5. Similarly enter Subnet mask of LAN port using command: 14-LAN Subnet Mask-#*.
6. Enter the WAN IP address using the command: 11-WAN IP Address-#* and enter WAN subnet mask
using the command: 13-WAN Subnet Mask-#*.
7. You can know the status of various network parameters on the display of your SLT. You can know the
connection type viz DHCP, PPPoE or Static, WAN IP address and subnet mask, LAN IP address and
subnet mask, Gateway address and DNS address.
8. Entering programming mode using command #18-1234 or #19-1234 and then enter the command 37-#*
to know the current connection type of ATA211. ATA211 will display the connection type on SLT display. If
the connection type is programmed as DHCP, you will get display for DHCP. Similarly you will get display
as PPPoE or Static as per type of connection.
9. Similarly, enter the command 31-#* to display the WAN IP address on SLT.
10. Enter the command 32-#* to display the LAN IP address on SLT.
11. Enter the command 33-#* to display the WAN subnet mask on SLT.
12. Enter the command 34-#* to display the LAN subnet mask on SLT.
13. Enter the command 35-#* to display the Gateway address on SLT.
To Next Page
Loading...
Need help?
General
