92 Matrix SETU ATA211 V1 System Manual
• Select CLI type as per CLI type supported by the exchange. Select from the options: None/DTMF/FSK-ITU
(V.23)/FSK-Bellcore.
• If 'CLI type' is programmed as 'None', the CLI will not be sent to FXS port.
• Program other option as supported by the exchange.
Default = DTMF.
Pause Timer
• While making the call from FXO port, ATA211 adds some 'delay' before dialing out the number after the
FXO port goes Off-hook. This delay is programmed as 'Pause timer'. During this time no digit is dialed by
the ATA. This is used for FXO line from some exchange which takes some time to detect that FXO port is
off-hook.
• If this delay is not programmed, the exchange misses the initial digit of the number dialed from ATA211 and
the call will not be placed.
• The Pause character '^' is used for applications like multi-stage dialing. Refer chapter “Using SETU
ATA211” for more details. To out dial the digits from FXO port with desired delay, it is programmed in the
number string which is to be dialed by ATA211.
• Refer chapter “Automatic Number Translation” for details of substitute number list.
• You can program the timer from 1 to 9 second. Default = 1 sec.
FXO Port Busy Wait Timer
• This timer is used when the 'FXO port busy wait timer' is programmed for the routing type 'Collect number
and route to FXO'. Refer chapter “SIP Accounts” for configuring Routing Option. The ATA211 will wait for
this time, for the The FXO port will be 'free' (idle), after expiry of this time. During this timer the caller will
get call routing tone (feature tone).
• Program this timer for which the ATA will wait for the FXO port to be free for routing the call.
Range is from 00 to 99 sec.
Default = 45 sec.
PIN Authentication
• This feature is used to allow incoming on the FXO port, only from desired callers.
• If it is enabled, the caller will be required to dial 'PIN' as programmed in ATA211, while calling to the
ATA211. Refer chapter “PIN Authentication” for more details.
Default = Disable.
Incoming calls
• Allow Incoming Calls?: This can be selected as Yes/No.
• Select 'Yes' if IC calls are to be allowed on the FXO port. If 'No' is selected, ATA211 will block the IC calls
on FXO port.
Default = Enable.
Route the Incoming Calls
• This is a call routing feature, used to define the destination route for the incoming call to ATA211. For
example, call on FXO port can be routed to the SIP or it can be routed to FXS port.
To Next Page
Loading...
Need help?
General
