Matrix SETU ATA211 V1 System Manual 33
Note1:
The Kernal Date helps SE to know whether the Kernal is required to be compiled for new version, to support any
new feature (e.g. VLAN) in ATA211, so that he can ask the user to send the ATA211 to Factory, in case it is required
to be compiled.
Note2:
The status for registration as 'Active' will be displayed for following cases:
• When Proxy SIP Account is enabled, registered and 'Send REGISTER?' flag is set to 'Yes'
or
• When Proxy SIP Account is enabled, not registered and 'Send REGISTER?' flag is set to 'No'
or
• When P2P Account is enabled (irrespective of 'Send REGISTER?' flag).
Refer chapter “SIP Accounts” for more details of parameter 'Send REGISTER?'.
Now your SETU ATA211 is ready for use!
LAN Port
IP Address Displays the IP address of LAN port currently used.
Subnet Mask Displays the subnet mask currently used.
MAC Address Displays the unique MAC address of LAN port.
WAN Port
IP Address Displays the IP address of WAN port currently used.
Subnet Mask Displays the subnet mask currently used.
Gateway Address Displays the gateway address currently used.
DNS Address Displays the domain name server address currently used.
DNS Domain Name Displays the DNS domain name currently used.
NTP Address Displays the NTP Server's Address currently used.
MAC Address Displays the MAC address of WAN port currently used either unique or cloned.
NAT Type Displays the type of NAT Type received in STUN response.
Router's Public IP Address. Displays the programmed router's public address.
IP Address fetched using STUN. Displays the IP address fetched using STUN.
SIP port fetched using STUN Displays the port fetched using STUN.
SIP Account1
Registration Status Displays the status for registration for the SIP Account, as Disable or
Registering or Active. (Refer Note2 below Table)
Registration Time Displays the registration time provided by server during registration.
Registration Retry Count Displays the number of attempts after failure, ATA sent registration request.
Reg. Last Failed Reason Display the messages about the reasons for registration last failed.
SIP Account2 Same as for SIP Account1.
SIP Account3 Same as for SIP Account1.
Auto Configuration
Status Displays the status after auto configuration is applied during power ON. e.g.,
"TFTP Server not found" "Auto Configured Successfully".
Statistics Displays the no. of files downloaded/configured as X/Y.
Parameter Description
To Next Page
Loading...
Need help?
General
