— 3.1 —
CHAPTER 3
WHEN ABNORMAL CONDITIONS
ARE ENCOUNTERED
This chapter describes how to correct troubles in the event that desired cutting results
are not obtained or a failure has occurred.
TABLE OF CONTENTS
CHAPTER 3 WHEN ABNORMAL CONDITIONS ARE
ENCOUNTERED ........................................................................................ 1
IF ANY OF THE BELOW-STATED PHENOMENA ......................................... 2
TAKES PLACE ........................................................................................................... 2
Cutting depth is insufficient. [CONDITION] > [PRESS CORRECT] .............................................. 2
The work remains uncut at the cutting start and end........................................................................... 2
[CONDITION] > [START/END CORRECT] ................................................................................... 2
Corrugated board is cut out at flutes though creasing is performed. [CONDITION] > [PRESS (Y)] 4
TOOLS ARE NOT ALIGNED TO EACH OTHER. [TOOL SELECT] ............... 5
TROUBLES FOR WHICH ERROR MESSAGES ARE ................................... 19
GIVEN ON THE LCD............................................................................................ 19
Errors that can be corrected by users ................................................................................................ 19
Errors that cannot be corrected by users ........................................................................................... 21
To Next Page
Loading...
Need help?
General
