— 2.50 —
INTERRUPTION OF PROCESSING
(PLOTTING, CUTTING OR CREASING)
Under the REMOTE mode, processing can be interrupted due to some reason.
The following explains how to interrupt the process and the function that enables the settings to be
changed after the interruption.
How to interrupt/resume the process
1 Press the
REMOTE
LOCAL
key while the device
is in operation.
After a while, the device stops its perfor-
mance and enters into the LOCAL mode.
• If the device is processing a circle, it
will stop after the completion of the
processing of the circle. For other line
segments, the device stops after pro-
cessing them in vectors.
2 Press the
REMOTE
LOCAL
key again.
The device enters the REMOTE mode to
resume processing.
Functions that can be specified after the interruption
The device is able to perform the following.
• Cutting conditions can be changed.
→ “Setting cutting conditions [CONDITION]” See page 2.28.
• Data remaining in the data receiving buffer can be cleared.
→ “Interruption of processing [DATA CLEAR]” See page 2.48.
To Next Page
Loading...
Need help?
General
