— 3.17 —
IF THERE IS A SIGN OF FAILURE
Corrective measures against troubles in the case where no error message is given on the LCD are
described in this section.
Refer to the description given in “Troubles for which error messages are given on the LCD” in
Chapter 3 for a trouble that is not covered in this section and accompanied by the indication of an
error message on the LCD.
See page 3.19.
The device not at all actuates even when the power to the device is turned on.
Cause Corrective measure Reference page
The device fails to actuate even when data is transmitted from CAD.
Cause Corrective measure Reference page
Error arises when transmitting data.
Cause Corrective measure Reference page
Is the power cable securely connected to the
device?
Properly connect the power cable to the
device.
Properly connect the power cable to the
device.
Release the EMERGENCY switch from the
pressed state.
P. 1.14
P. 1.19
Is the device set in the LOCAL mode?
Is the interface cable securely connected to
the device?
Set the device to the REMOTE mode.
Properly connect the interface cable to the
device.
P. 1.20
P. 1.13
Do communication conditions match those on
the computer?
Do commands on the computer match those
on the plotter?
Adjust the communication conditions to those
on the computer.
Adjust the commands on the plotter to those
on the computer.
P. 1.22
P. 1.28
To Next Page
Loading...
Need help?
General
