— 4.1 —
CHAPTER 4
APPLICATION FUNCTIONS
This chapter describes helpful functions that facilitate operation.
TABLE OF CONTENTS
CHAPTER 4 Application functions .......................................................... 1
ASSIGNMENT OF PEN NUMBERS [MODE SET] > [PEN ASIGN] .............. 2
RE-CUT OF THE SAME DATA [COPY] ............................................................ 4
SETTING THE NUMBER CUT FUNCTION ...................................................... 6
[MODE SET] > [MULTI-PASS] ................................................................................. 6
SETTING THE ONE-STROKE CUTTING .......................................................... 8
[MODE SET] > [ONE STROKE] ............................................................................. 8
SETTING THE CUTTER STROKE [MODE SET] > [Z STROKE] ............. 10
SETTING THE UNIT TO BE USED FOR INDICATION ............................. 11
[MODE SET] > [UNIT] ............................................................................................ 11
SETTING THE DUMMY CUT OPERATION OF ........................................... 12
THE SWIEVEL BLADE [MODE SET] > [DUMMY CUT] ............................ 12
INTERFACE OF COMMUNICATION CONDITIONS [INTEFACE] ................ 14
ALIGNMENT OF MECHANICAL AXES TO................................................... 16
RULED LINES PRINTED [AXIS ALIGN] ........................................................ 16
To Next Page
Loading...
Need help?
General
