— 2.13 —
3 Pressing the dial in the direction of the
arrow, tighten the dial stopper.
• The dial has a play. To elimi-
nate an error in the projecting
amount of the blade tip, tighten
the dial stopper while keeping
the dial held pushed in the di-
rection of the arrow.
Cutter holder 2N (for unit B)
Cutter holder 2N is a tangential cutter used for the unit B.
The unit B (reciprocal head) is used for non-reciprocal operation. (For the cutting conditions, refer
to page 2-26.) Works of up to 2 mm thick can be cut.
• The carbide blades (SPB-0045, 0046) and high-speed steel blades (SPB-0043, 0044)
are the tools that can be used.
The adjustment method is the same as that described above for cutter holders 4N and 10N. Please
refer to that section.
To Next Page
Loading...
Need help?
General
