MIMAKI CF-0912 User Manual

TURNING THE POWER ON/OFF
The device is provided with separate switches for turning the power on and off. Turn on/off the
power to the device following the procedure described below.
•Do not place any thing other than a work on the cutting panel when turning the
power on.
Turning the power on causes the head to travel to the retracted point located at the
lower right of the cutting panel. If a thing is present on the cutting panel, the head
may come in contact with the thing, giving rise to a failure.
• If the device is restarted, do not turn on the power until 30 minute after turning off.
The device may be caused faulty function.
Turning the power on
1
Confirm nothing is placed on the cut-
ting panel.
If there is a thing on the cutting panel,
remove it from the panel.
2 Press the POWER ON switch .
The POWER lamp lights up (in green).
The head travels to the retracted point
(at the lower right) on the cutting panel.
Then, the first page of the local menus
will appear on the LCD.

MIMAKI CF-0912 Specifications

General

Brand	MIMAKI
Model	CF-0912
Category	Plotter
Language	English