V Series Operating Instructions 18 - 9
Cardiac Output (CO) (Optional) CO Digital Tile Layout
18.4 CO Digital Tile Layout
The CO digital tile displays:
1. CO/CI tile label
2. Message area
3. CI value
4. High and low alarm limits
5. Units of measure
6. TBlood value
7. TBlood label
8. CO timestamp
9. CO source
10. CO value
FIGURE 18-5 Example CO Digital Tile
18.4.1 About the CO Tile
CO and CI Parameter
• The CO parameter displays CO in units of l/min with a resolution of 0.1 l/min.
• The CI parameter displays CI in units of l/min/m² with a resolution of 0.1 l/min/m².
• If the CO/CI measurement is invalid, “- -” displays in place of digits.
• The CO tile displays a timestamp.
NOTE: The timestamp only displays after accepting a CO average.
TBlood Parameter
• The TBlood parameter displays TBlood in the configured units of measure, with a resolution of
0.1°C when the unit of measure is Celsius and 0.1°F when the unit of measure is Fahrenheit.
• If the TBlood measurement is invalid, “- -” displays in place of digitals.
18.4.2 CO Alarms
Refer to the "Temp Tab" on page 8-7 for additional information.
To Next Page
Loading...
Need help?
General
