Introduction Gases (Optional)
2 - 2 Addendum to V Series Operating Instructions
2.1 Introduction
The V 12/V 21 works with Mindray DS Gas Module 3 to measure and monitor inspired and expired
O
2
, CO
2
, N
2
O and five (5) anesthetic agents--Isoflurane (ISO), Sevoflurane (Sev), Desflurane (Des),
Halothane (Hal), and Enflurane (Enf).
Mindray DS Gas Module 3 is a leading-edge breath-by-breath
gas analyzer, which delivers state-of-
the-art gas monitoring and analysis capabilities. Refer to Gas Module 3 Operating Instructions (P/
N 0070-10-0696-02) for additional information regarding the use and maintenance of the device.
This chapter describes the Gas module in detail, including how to configure Gas alarm limits,
configure the Gas parameter, calibrate and monitor gases.
The V 12/V 21 gase
s monitoring provides:
• awRR: Airway Respiratory Rate
• MAC: Minimal Alveolar Concentration
• inspired and expired values for CO
2
, O
2
, N
2
O and AA.
• CO
2
waveform
NOTE: AA represents one of five (5) anesthetic agents--Hal, ISO, Enf, Sev, and
Des.
NOTE: This module does not display O
2
monitoring for AION 2.5G AG module.
Patient Sizes
Intended patient types: Adult, Pediatric, Neonate.
VDI Module Connector
The VPS module does not include the Gases parameter. The Gases parameter is available through the
serial port of a separate module called the V Device Integrator (VDI) (as shown in FIGURE 2-1).
FIGURE 2-1 Example VDI Module Connector
Display Setup
To see the Gas values, Gases must be configured to display on the Main Screen. Refer to "Display
Options Dialog" on page 3-2 in the V Series Operating Instructions for additional information.
To Next Page
Loading...
Need help?
General
