MR ETOS TD User Manual

9 Visualization
Maschinenfabrik Reinhausen GmbH 2020 1234453918/14 EN ETOS
®
TD
Load-dependent mode: Overrun time
You can use this parameter to set the time period for which the cooling
stages remain switched on when the transformer load current returns to a
value below the set switching point.
9.10.5 Configuring periodic mode
Periodic mode is used to prevent the bearings of the cooling stages from
seizing up as a result of long idle periods. To do this, the cooling stages are
operated for a certain period at regular intervals regardless of the measured
temperature. You can activate/deactivate periodic mode individually for ev-
ery cooling stage (Configuring cooling stages [►Section 9.10.1, Page 119]).
Settings
Parameters
Cooling ...rol
Name Value
Operating mode Manual
Load-dep. mode Off
Load-dep. mode: Switching point 100.0%
Load-dep. mode: Switch-on delay 2.0min
Load-dep. mode: Overrun time 30.0min
Activate period. mode Off
Period. mode: Interval 24h
Period. mode: Switch-on duration 30min
Period. mode: Switch-on delay 120min
Activate altern. mode Off
Altern. mode: Change interval 24h
Home
Events
Information
Recorder
Settings
EN
CHANGE
REBOOT
admin 04.02.2020 10:14
Figure88: Cooling system control
1. Go to Settings > Parameters > Cooling system > Cooling system con-
trol.
2. Select the desired parameter.
3. Set the parameter.
4. Press the Accept button to save the modified parameter.
Activate periodic mode
You can use this parameter to activate the periodic mode of the cooling sys-
tem control.
Periodic mode: Interval
You can use this parameter to set the time period after which the cooling
stages are to be switched on for the first time.
Periodic mode: Switch-on duration
You can use this parameter to set the length of time that the cooling stages
are to be switched on for.

MR ETOS TD Specifications

General

Brand	MR
Model	ETOS TD
Category	DC Drives
Language	English