194
Various System Settings
Section 6-9
6-9-5 Setting the “Printer Controller”
The NT31/NT31C has a function for printing out data at a printer connected to it in
response to an instruction from the host or operation at the NT31/NT31C. Three
types of printer can be connected to the NT31/NT31C: select the type used with
this memory switch setting.
S ESC/P:
Printers that conform to the ESC/P 24-J83C (color) printer control specifica-
tions or printers that conform to the ESC/P 24-J82 (monochrome) control
specifications.
S PC-PR201H:
Printers that can emulate the PC-PR201H, made by NEC Corp.
S PCL 5:
Printers that conform to the PCL 5 printer control specifications.
Note that the NT31 can only be used with the monochrome “Tone” setting and
does not support color printing.
For the NT31, the “Print Method” is fixed as “Tone”.
The default (factory) setting is “ESC/P”.
Reference - In addition to this setting, NT31C has the “Print Method” setting (page 195).
- For details on the print function, refer to 7-15-7 “Print Function” (page 458).
Set the printer controller setting by following the menu operation from the System
Menu shown below.
Select “Maintenance Mode”.
Select “Memory Switch”.
To Next Page
Loading...
Need help?
General
