463
Special Functions
Section 7-16
7-16 PT Configuration Settings
Apart from the settings of the memory switches at the NT31/NT31C itself, the ba-
sic operationof the NT31/NT31C is also determined by the “PT Configuration” set-
tings made at the Support Tool.
This section describes the settings made under “PT Configuration”. However,
note that the operations at the Support Toolarenot described. For details on these
operations, refer to the NT-series Support Tool Ver. 3.0 for Windows95 Operation
Manual (V053-E1-j).
7-16-1 “PT Configuration” Settings
There are the following PT Configuration settings.
[PT Model]
Set the type of PT to be connected. (Refer to 8-1 “Screen Creation Procedure”
(page 392)
[PLC Vendor]
Set the direct connection type from either of the followings
-OMRON
- Mitsubishi--A
- Mitsubishi-FX
-MEMLINK
[Font Type]
Set the font type used for the screen data to be created.
The following two font types are available.
- CP437
- ISO 8859-1
[Comments]
Set a comment relating to screen data here. This comment is displayed on the
screen on manual transmission of memory unit.
[PT Control Area/PT Notify Area]
Set the allocated words for the PT status control area, PT status notify area and
windowcontrol area here. Refer to 7-2 “Areas for Control/Notification” (page265).
[Initial Screen]
Set the screen number of the screen that is displayed when NT31/NT31C opera-
tion starts. However, note that the screen set here is displayed as the initial screen
only when the setting made for the “screen switch setting” word in the PT status
control area is not a correct screen number. For details, refer to “Functions of the
PT Status Control Area” (page 266).
[History Setting]
Set the processing method when the record areas for the display history function
and alarm history function become full. Refer to “Alarm list/history function” (page
299).
To Next Page
Loading...
Need help?
General
