667
Compatibility with Screen Data of Other PT Models
APPENDIX I
APPENDIX I
Compatibility with Screen Data of Other PT Models
The screen data of the NT31/NT31C does not have complete upward compatibility with the screen data for earlier
PT models. Consequently, when the data for an earlier PT model is converted for an NT31/NT31C use, partial
modification may be necessary.
The combinations for which data conversion is possible are shown below. Note that “Ver. j” indicates the direct
connection version. The NT-series Support Tool Ver. 2.0 for Windows95 is compatible with the latest version of
each PT model.
NT20S
(Ver. 5)
NT30
(Ver. 4)
NT30C
(Ver. 4)
NT31 (–V1) NT31C (–V1)
NT600S
(Ver. 5)
NT610G, NT620S
(Ver. 4)
NT610C, NT620C, NT625C
(Ver. 4)
NT631 (–V1) NT631C (–V1)
** * *
* Data conversion is not possible from the new models with “-V1” to the new models without “-V1”.
However, data for models with no “-Vj” suffix of NT20S-ST121 and NT600S-ST121/211, cannot be read with the
Support Tool (NT-ZJ3M
After data conversion, the following discrepancies may occur; in this case modify the data.
S When the data of NT20S, NT600S, NT610G, or NT620S is converted, the position and size of touch switches may
change due to the difference in the dot size of touch switches.
S Since the size and contents of the PT status control area and PT status notify area differ between the new models
(NT31, NT31C, NT631, NT631C) and earlier models, the program at the host (PC) must be modified.
To Next Page
Loading...
Need help?
General
