242
Programming Console Function
Section 6-12
6-12 Programming Console Function
As an expansion function, the NT31/NT31C features the “programming console
function”, which allows it to be used instead of a programming console (type
C200H-PRO27-E) for a C-series CPM1, CQM1, C200HX/HG/HE (–ZE), or
CS1-series CS1G/CS1H.
Except for recording (saving) ladder programs on cassette tape and replaying
(reading) them, almost all the functions of a programming console can be execut-
ed.
Note When the programmable controller functions are used, carefully check that the
system is safe before carrying out the following operations.
- Changing monitor data
- Switching the operating mode
- Forced set or reset
- Changing a present value or set value
To Next Page
Loading...
Need help?
General
