A device may pair automatically after connecting to the network. However, you may need to manually pair a device in the
following situations:
• The device doesn’t automatically pair during setup with the system you purchased.
• You want to pair the device with a different system.
• You want to pair multiple similar devices (for example, to control the system with more than one Poly TC8 device).
Note: The Enable New Device Auto-Pairing setting applies only to link-local network (LLN) devices; not devices
connected to the primary network.
Task
1 Connect the device you want to pair to an Ethernet port in the room.
2 In the system web interface, go to General Settings > Device Management.
3 Under Available Devices, find the device by its MAC address (for example, 00e0db4cf0be) and select Pair.
If paired successfully, the device displays under Connected Devices with a Connected status. If a device shows a
Disconnected status, this indicates that pairing wasn’t successful.
If pairing isn’t successful, check the network connection, the configuration of your device, and the system you’re pairing
with.
Unpair an IP Device
You must unpair an IP device if you no longer want to use it with a particular video system.
Don’t unpair devices if you plan to use them with the same system. For example, if you move your video-conferencing
equipment to another room, just disconnect and reconnect the devices in the new location.
Note: If you unpair a link-local network (LLN) device, it won’t automatically pair again with the same system.
Task
1 In the system web interface, go to General Settings > Device Management.
2 Under Connected Devices, find the device by its MAC address (for example, 00e0db4cf0be) and select Unpair.
The unpaired device moves from Connected Devices to Available Devices (which shows discovered devices you can
pair with the system).
Connect a USB Device
You can use some devices, such as a Windows or Mac laptop, with a USB connection to your video system. See the latest
Release Notes for supported USB devices.
Task
» Connect the device to a USB port on the back of your system.
Poly Bluetooth Remote Control
You can use the Poly Bluetooth Remote Control with your system.
Use the system web interface to perform the following tasks:
• Configure a remote control’s button behavior.
• Pair and unpair a remote control.
Note: The remote control included with your G7500 system purchase is paired and ready to use without any extra
setup.
• View the remote control name, pairing status, and battery level.
21
To Next Page
Loading...
Need help?
General
