• The system doesn’t respond to CEC commands from a monitor remote control.
• If a monitor is connected to two endpoints, the monitor displays the active endpoint when the other is sleeping.
Disable CEC
Disable CEC in the system web interface.
Task
1 In the system web interface, go to Audio/Video > Monitors.
2 Clear the Enable Consumer Electronics Control check box.
Enable CEC
Enable CEC in the system web interface.
Make sure your monitor’s CEC settings are configured correctly (see your monitor’s documentation).
Task
1 In the system web interface, go to Audio/Video > Monitors.
2 Select the Enable Consumer Electronics Control check box.
Configure General Camera Settings
You can configure settings for cameras connected to your system. The system automatically discovers your camera model
and displays the relevant settings in the system web interface.
See the latest Release Notes for specific information about the cameras you can use with your system.
Note: If you connect an unsupported camera, the system still attempts to show video. Poly can’t guarantee that the
results are optimal or that the available settings are the same as a supported camera.
Task
1 In the system web interface, go to Audio/Video > Video Inputs > General Camera Settings.
2 Configure the following settings:
Setting
Description
Allow Other Participants in a Call to Control Your Camera Specifies whether the far site can pan, tilt, or zoom the near-site
camera. When you enable this setting, a user at the far site can
control the framing and angle of the camera for the best view of
the near site. This is also called Far End Camera Control (FECC).
Power Frequency Specifies the power-line frequency for your system.
Your system typically defaults to the correct power-line
frequency based on the video standard used in the country
where it’s located. This setting helps you adapt the system to
areas where the frequency doesn’t match the video standard.
You might also need to change this setting to avoid flicker from
fluorescent lights in the room.
Enable Camera Preset Snapshot Icons Enables the use of snapshot icons that represent camera
presets.
To see a preset icon, you must enable this setting before
configuring the preset.
87
To Next Page
Loading...
Need help?
General
