To Next Page

To Previous Page

Enable or Disable Content Saving

Enable or disable content saving from the Pano App for users who connect to the primary or secondary network.

Task

1 In the system web interface, go to Security > Content.

2 Select or deselect Allow users to save content from Primary Network and Allow users to save content from Wi-Fi

Network.

System Allow List

The allow list enables access to your system web interface and SNMP ports only to IP addresses you specify.

An allow list supports up to 30 addresses (including IPv4 and IPv6 formats) and can only be configured in the system web

interface.

Note: If your IP addresses are dynamically assigned, make sure the allow list is updated so those hosts can connect to

your system.

Add IP Addresses to the Allow List

You can add and edit specific IP addresses to an allow list for your system.

Warning: Once you save the IP allow list, you can access the system web interface of only those devices on the list. If your

current device isn’t on the list, you can’t access the system web interface for that device. You may have to factory restore

the system to regain access.

Task

1 In the system web interface, go to Security > Access.

2 Select Enable Allow List, then Edit Allow List.

3 Select address type IPv4 or IPv6.

4 In the IP Address field, enter the address of the system you want to add to the allow list.

5 Select Add.

6 Optional: Repeat steps 4 and 5 for the other IP addresses you want to add to the allow list.

7 Select Save.

Delete IP Addresses from the Allow List

You can delete specific IP addresses from the allot list for your system.

Task

1 In the system web interface, go to Security > Access.

2 Select Edit Allow List.

3 Select the check box next to any IP address you want to delete and select Remove.

IPv4 Address Formats

The configuration requires a single IP address, a range of addresses, or an IP and netmask. (The netmask represents the

number of valid bits of the IPv4 address to use.)

The following are valid IPv4 formats for your G7500 and Studio X series system:

• 10.12.128.7

• 172.26.16.0/24

IPv6 Address Formats

For IPv6 addresses, you can use a Classless Inter-Domain Routing (CIDR) notation to represent a range of IP addresses.

Poly P014 User Manual

Questions and Answers: