Manage the System Remotely
Polycom, Inc. 164
Download MIB
Set Up SNMP Management
To configure the RealPresence Group system for SNMP Management:
1 In the web interface, go to Admin Settings > Servers > SNMP.
2 Configure these settings on the SNMP screen, then click Save.
Setting Description
Enable SNMP Allows administrators to manage the system remotely using SNMP.
Enable Legacy
Notifications
Supports sending notifications that are compatible with the legacy MIB.
Enable New
Notifications
Supports sending notifications that are compatible with the new MIB.
Version1 Enables the use of the SNMPv1 protocol.
Version2c Enables the use of the SNMPv2c protocol.
Version3 Enables the use of the SNMPv3 protocol.
You must select this setting to use the subsequent settings that apply only to SNMPv3.
Read-Only
Community
Specifies the SNMP management community in which you want to enable this system. The
default community is public.
Note: Polycom does not support SNMP write operations for configuration and provisioning;
the read-only community string is used for both read operations and outgoing SNMP traps.
Contact Name Specifies the name of the person responsible for remote management of this system.
Location Name Specifies the location of the system.
System Description Specifies the type of video conferencing device.
User Name Specifies the SNMPv3 User Security Model (USM) account name that will be used for
SNMPv3 message transactions. The maximum length is 64 characters.
Authentication
Algorithm
Specifies the type of SNMPv3 authentication algorithm used:
• SHA
• MD5
Authentication
Password
Specifies the SNMPv3 authentication password. The maximum length is 48 characters.
Privacy Algorithm Specifies the type of SNMPv3 cryptography privacy algorithm used:
• CFB-AES128
• CBC-DES
Privacy Password Specifies the SNMPv3 privacy (encryption) password. The maximum length is 48
characters.
To Next Page
Loading...
Need help?
General
