Control and Navigation
Polycom, Inc. 185
3 In the web interface, go to Admin Settings > General Settings > Date and Time > Time in Call.
4 Configure these settings.
Configure Polycom Touch Control Regional Settings
To configure the Polycom Touch Control regional settings:
1 From the Home screen touch Administration.
2 Touch the Location tab.
3 Select a language from the Language menu.
4 Configure the following settings under Date and Time.
Time Server Specifies whether the connection to a time server is automatic or manual for system time
settings. You can also select Off to enter the date and time yourself.
Primary Time
Server Address
Specifies the address of the primary time server to use when Time Server is set to Manual.
Secondary Time
Server Address
Specifies the address of the time server to use when the Primary Time Server Address
does not respond. This is an optional field.
Current Date and
Current Time
• If the Time Server is set to Manual or Auto, these settings are not displayed.
• If the Time Server is set to Off, these settings are configurable.
Setting Description
Show Time in Call Specifies the time display in a call:
•Elapsed Time—Displays the amount of time in the call.
• System Time—Displays the system time on the screen during a call.
•Off—Time is not displayed.
When to Show Specifies when the time should be shown:
• Start of the call only—Displays only when the call begins.
• Entire call—Displays continuously throughout the call.
• Once per hour—Displays at the beginning of the hour for one minute.
• Twice per hour—Displays at the beginning of the hour and midway through the hour
for one minute.
Show Countdown
Before Next Meeting
This setting is displayed only when the calendaring service has been enabled.
When enabled, it displays a timer that counts down to the next scheduled meeting 10
minutes before that meeting. If a timer is already showing, the countdown timer replaces it
10 minutes before the next scheduled meeting.
Setting Description
To Next Page
Loading...
Need help?
General
