EasyManuals Logo
Home>Polycom>Conference System>realpresence group series

Polycom realpresence group series Administrator's Manual

Polycom realpresence group series
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Networks
Polycom, Inc. 47
Enable LLDP in the Web Interface After the Setup Wizard Process
If you have already gone through the setup wizard and do not want to reset your RealPresence Group
system to run the setup wizard again, you can configure LLDP in the web interface.
To enable LLDP in the web interface:
» In the web interface, go to Admin Settings > Network > LAN Properties. Select the check box at
Enable LLDP and click Save.
Enable LLDP in the Local Interface After the Setup Wizard Process
If you have already gone through the setup wizard and do not want to reset your RealPresence Group
system to run the setup wizard again, you can configure LLDP in the local interface.
To enable LLDP in the local interface:
In the local interface, go to Settings > Administration > LAN Properties. Select the Enable LLDP check
box.
Configure IP Settings
You can configure IP network settings only through the web interface by going to Admin Settings >
Network > IP Network.
Network Quality Settings
Use this group of settings to specify how your RealPresence Group system responds to quality issues.
H.323 Settings
If your network uses a gatekeeper, the system can automatically register its H.323 name and extension.
This allows others to call the system by entering the H.323 name or extension instead of the IP address.
Setting Description
Automatically Adjust
People/Content Bandwidth
Specifies whether the system should automatically adjust the bandwidth
necessary for the People stream or Content stream depending on the relative
complexity of the people video, content video, or both.
Quality Preference Specifies which stream has precedence when attempting to compensate for
network loss:
•Both People and Content streams
People streams
•Content streams
The stream defined to have precedence experiences less quality degradation
during network loss compensation than the stream not having precedence.
Choosing Both People and Content streams means that both streams
experience roughly equal degradation.
This setting is not available when the Automatically Adjust People/Content
Bandwidth setting is enabled.

Table of Contents

Other manuals for Polycom realpresence group series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom realpresence group series and is the answer not in the manual?

Polycom realpresence group series Specifications

General IconGeneral
BrandPolycom
Modelrealpresence group series
CategoryConference System
LanguageEnglish

Related product manuals