The following explains how to configure a IPv6 address to 2001:DB8::100 with prefix length 64 on
the Ethernet interface.
msh> ifconfig ether inet6 2001:DB8::100 64
Netmask configuration
msh> ifconfig "interface_name" netmask "address"
The following explains how to configure a subnet mask 255.255.255.0 on Ethernet interface.
msh> ifconfig ether netmask 255.255.255.0
Broadcast address configuration
msh> ifconfig "interface_name" broadcast "address"
Changing the Interface
msh> ifconfig "interface" up
You can specify either the Ethernet interface or IEEE 802.11b interface when using the optional IEEE
802.11b interface unit is installed.
• To get the above addresses, contact your administrator.
• Use the default configuration if you cannot obtain setting addresses.
• The IP address, subnet mask and broadcast address are the same as that for the ethernet interface
and IEEE 802.11b interface.
• TCP/IP configuration is the same for both Ethernet and IEEE 802.11 interface. If interfaces are
changed, the new interface inherits the configuration.
• Use "0x" as the initial two letters of a hexadecimal address.
info
Use the "info" command to display printer information such as paper tray, output tray, and printer language.
Printer information display
msh> info
• For details about displayed contents, see p.260 "Getting Printer Information over the Network" .
ipp
Use the "ipp" command to view and configure IPP settings.
Remote Maintenance by telnet
237
To Next Page
Loading...
Need help?
General