line whenever a packet is transferred from the printer.If there is more than one DHCP server,
use the same setting for all servers. The printer operates using data from the DHCP server
that responds first.
Using AutoNet
If the printer IPv4 address is not assigned by a DHCP server automatically, a temporary IPv4 address
starting with 169.254, which is not used on the network, can be automatically selected by the printer.
You must change this setting to "on" to use AutoNet.
• The IP address assigned by the DHCP server is given priority over that selected by AutoNet.
• You can confirm the current IPv4 address on the configuration page.
• When AutoNet is running, the NetBIOS name is not registered on the WINS server.
• The printer cannot communicate with devices that do not have the AutoNet function. However, this
printer can communicate with Macintosh computers running Mac OS X 10.2.3. or higher.
• For more information about the configuration page, see p.170 "List/Test Print Menu" .
• See p.226 "Remote Maintenance by telnet" .
Configuring the WINS Server
The printer can be configured to register its NetBIOS name with a WINS server when the power is turned
on. This enables the NetBIOS name of the printer to be specified from SmartDeviceMonitor for Admin even
in a DHCP environment. This section explains configuring the WINS server.
• The WINS server is supported with Windows NT 4.0 Server Service Pack 4 or higher, and Windows
2000 Servers WINS Manager.
• For details about the WINS server settings, see Windows Help.
• If there is no reply from the WINS server, the NetBIOS name is registered by broadcast.
• The NetBIOS name can be entered using up to 13 alphanumeric characters.
Using Web Image Monitor
1. Start a Web browser.
11. Appendix
360
To Next Page
Loading...
Need help?
General