Message List
This is a list of messages that appear in the printer's system log. The system log can be viewed using the
"syslog" command.
System Log Information
Use the following command to display the system log information:
• UNIX: Use the "syslog" command and "rsh", "rcp", "ftp", and "sftp" parameters.
• telnet : Use the "syslog" command.
Message Problem and solutions
Access to NetWare server <file server name> de-
nied. Either there is no account for this print server
on the NetWare server or the password was in-
correct.
(In the print server mode) Login to the file server
failed. Make sure that the print server is registered
on the file server. If a password is specified for the
print server, delete it.
account is unavailable: Same account name be
used.
User account is disabled. This could be because it
use the same account name as the administrator
account.
account is unavailable: The authentication pass-
word is not set up.
User account is disabled. This could be because the
authentication password is not set, and only the
encryption account is set.
account is unavailable: encryption is impossible. Encryption is not possible and account is disabled.
This could be because:
• Security option is not installed.
• Encryption password has not been specified.
add_sess_IPv4: bad trap<IPv4 address>,
community:<community name>
The IPv4 address (0.0.0.0.) is unavailable when
the community access type is TRAP. Specify the host
IPv4 address for the TRAP destination.
add_sess_IPv6: bad trap<IPv6 address>,
community:<community name>
The IPv6 address [::] is unavailable when the com-
munity access type is TRAP. Specify the host IPv6
address for the TRAP destination.
add_sess_IPv4: community<community name> al-
ready defined.
The same community name already exists. Use an-
other community name.
Message List
281
To Next Page
Loading...
Need help?
General