Getting Printer Information over the Network
This section explains details of each item displayed in the printer status and information.
Current Printer Status
The printer status can be checked using the following commands:
• UNIX: Use the "lpq" command and "rsh", "rcp", "ftp" and "sftp" parameters.
• mshell: Use the "status" command.
Messages Description
Access Restricted The job was canceled because user have no au-
thority.
Add staples (Booklet: Back) The staple of booklet finisher (back) is exhaust-
ed.
Add staples (Booklet: Both) The staple of booklet finisher is exhausted.
Add staples (Booklet: Front) The staple of booklet finisher (front) is exhausted.
Adjusting... The printer is initializing or calibrating.
Call Service Center There is a malfunction in the printer.
Canceled The job is reset.
Canceling Job... The job is being reset.
Cannot multi-install: SD Card SD card you are trying to install has already
been installed in a different machine.
Card/Counter not inserted The printer is waiting for prepaid card or key.
Coin or amount not inserted The printer is waiting for coin to be inserted.
Coin/Key Counter not inserted The printer is waiting for coin or key counter.
Configuring... Setting is being changed.
Cooling Down Fusing Unit... Fusing unit is cooling down.
Cover Open: Bridge Unit Left The left cover of the Bridge Unit is open.
Cover Open: Bridge Unit Right The right cover of the Bridge Unit is open.
6. Monitoring and Configuring the Printer
260
To Next Page
Loading...
Need help?
General