Rockwell Automation Publication 7000L-UM301F-EN-P - March 2020 109
Operator Interface Chapter 3
A screen typical of Figure 92 will be displayed. To modify the text refer to the
section entitled Edit Text
on page 114, noting the following exception. When the
text has been entered (as in Figure 93
) the enter key has no effect. Press the exit
key [F10] to accept the edited string.
Prior to exiting the screen, the string can be returned to its state upon entry to the
screen by pressing the [F7] key.
Figure 92 - Edit the Drive Name
Figure 93 - Editing Complete
Transfer Data in Memory
The operator interface contains long term storage in two forms. Flash memory
contained in the operator interface is used to store the firmware and optionally
language modules and parameters used in the drive. This information can also be
stored on a removable flash card that can be taken to another drive.
In order to transfer information from the two forms of memory, press the [F7]
key. This displays a new screen (Figure 158
) from which all flash memory
operations are performed. Refer to the section entitled Flash Memory Transfers
on page 148 for instructions on these features.
To Next Page
Loading...
Need help?
General
