Rockwell Automation Publication 7000L-UM301F-EN-P - March 2020 91
Chapter 3
Operator Interface
Chapter Objectives
This chapter describes how you use the operator interface to modify and obtain
information contained within the drive. In this chapter you will learn how to:
• Modify information associated with the initial drive setup.
• View:
• drive parameters
• drive status
• View and Reset Alarm Conditions.
• Request printouts of the information in the drive.
• Perform diagnostic trending.
• Modify the operation of the operator interface.
The chapter deals only with the operation of the operator interface. Specific
references to a particular parameter are only for illustrative purposes. Refer to
Publication 7000-TD002
for information about the actual 'tags' within the drive
and their use.
Terminology
Parameter – A memory location within the drive to which data may be written
to or read. Setting a parameter (i.e. writing to it) will modify how the drive
behaves. Prior to using the drive a number of parameters must be set. Additional
parameters may be changed while the drive is in use in order to adjust its
operation, (i.e. the speed could be changed via a parameter).
Read-only Parameter – A memory location which can only be read. A read-only
parameter contains real-time data and is used to read the current conditions
within the drive, such as running speed.
Tag – A generic reference to either a parameter or a read-only parameter.
PanelView 550 – The PanelView™ 550 is a product marketed by Rockwell
Automation consisting of a hardware terminal and a software package, integrated
into a single product. The Medium Voltage Drive only uses the hardware portion
of the product and has replaced the software package.
PowerFlex™ Operator interface – References to the operator interface refer to
the product consisting of the PanelView 550 interface hardware and the unique
software contained within it, which allows it to function with the Medium
Volta g e Drive.
To Next Page
Loading...
Need help?
General
