100
MFX Parameters
21: Rotary 3
This type includes an overdrive. By distorting the sound you can
produce the intense organ sound used in hard rock.
L out
R out
RotaryOverdrive
L in
R in
Parameter Value Explanation
Speed # SLOW, FAST
Rotational speed of the rotating
speaker
Brake # OFF, ON
Switches the rotation of the rotary
speaker.
When this is turned on, the rotation
will gradually stop.
When it is turned o, the rotation will
gradually resume.
OD Switch OFF, ON Overdrive on/o
OD Gain # 0–127
Overdrive input level
Higher values will increase the
distortion.
OD Drive # 0–127 Degree of distortion
OD Level 0–127 Volume of the overdrive
Woofer Slow
Speed
0.05–10.00 Hz
Low-speed rotation speed of the
woofer
Woofer Fast
Speed
0.05–10.00 Hz
High-speed rotation speed of the
woofer
Woofer Trans Up 0–127
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Slow to Fast.
Woofer Trans
Down
0–127
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Fast to Slow.
Woofer Level 0–127 Volume of the woofer
Tweeter Slow
Speed
0.05–10.00 Hz
Settings of the tweeter
The parameters are the same as for
the woofer.
Tweeter Fast
Speed
0.05–10.00 Hz
Tweeter Trans Up 0–127
Tweeter Trans
Down
0–127
Tweeter Level 0–127
Spread 0–10
Sets the rotary speaker stereo image.
The higher the value set, the wider the
sound is spread out.
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Level # 0–127 Output Level
22: Chorus
This is a stereo chorus. A lter is provided so that you can adjust the
timbre of the chorus sound.
L in
R in
Chorus
Chorus
L out
R out
2-Band
EQ
2-Band
EQ
Balance W
Balance W
Balance D
Parameter Value Explanation
Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the frequency range above
the Cuto Freq
HPF: cuts the frequency range below
the Cuto Freq
Cuto Freq 200–8000 Hz Basic frequency of the lter
Pre Delay 0.0–100.0 ms
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level