IFX Parameters
77
25: Step Flanger
This is a anger in which the anger pitch changes in steps. The
speed at which the pitch changes can also be specied in terms of a
note-value of a specied tempo.
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Parameter Value Explanation
Filter Type
Type of lter
OFF No lter is used
LPF
Cuts the frequency range above the
Cuto Freq
HPF
Cuts the frequency range below the
Cuto Freq
Cuto Freq 200–8000 Hz
Center frequency when using the lter
to cut a specic frequency range
Pre Delay 0.0–100 msec
Adjusts the delay time from when the
direct sound begins until the anger
sound is heard.
Rate
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback -98–+98 %
Adjusts the proportion of the anger
sound that is fed back into the eect.
Negative (-) settings will invert the
phase.
Step Rate
0.10–20.00 Hz,
note
Rate (period) of pitch change
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the anger sound (W)
Level 0–127 Output Level
26: Hexa-Chorus
Uses a six-phase chorus (six layers of chorused sound) to give
richness and spatial spread to the sound.
Balance W
Balance W
L in
R in
L out
R out
Hexa Chorus
Balance D
Balance D
Parameter Value Explanation
Pre Delay 0.0–100 msec
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0–127 Depth of modulation
Pre Delay
Deviation
0–20
Adjusts the dierences in Pre Delay
between each chorus sound.
Depth Deviation -20–+20
Adjusts the dierence in modulation
depth between each chorus sound.
Parameter Value Explanation
Pan Deviation
0–20
Adjusts the dierence in stereo
location between each chorus sound.
0 All chorus sounds will be in the center.
20
Each chorus sound will be spaced
at 60 degree intervals relative to the
center.
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
27: Tremolo Chorus
This is a chorus eect with added Tremolo (cyclic modulation of
volume).
Tremolo Chorus
R in
R out
Balance D
Balance D
Balance W
Balance W
Parameter Value Explanation
Pre Delay 0.0–100 msec
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Chorus Rate
0.05–10.00 Hz,
note
Modulation frequency of the chorus
eect
Chorus Depth 0–127 Modulation depth of the chorus eect
Tremolo Rate
0.05–10.00 Hz,
note
Modulation frequency of the tremolo
eect
Tremolo
Separation
0–127 Spread of the tremolo eect
Tremolo Phase 0–180 deg Spread of the tremolo eect
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the tremolo chorus
sound (W)
Level 0–127 Output Level
28: Space-D
This is a multiple chorus that applies two-phase modulation in stereo.
It gives no impression of modulation, but produces a transparent
chorus eect.
L in
R in
Space D
Space D
L out
R out
2-Band
EQ
2-Band
EQ
Balance W
Balance W
Balance D
Parameter Value Explanation
Pre Delay 0.0–100 msec
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level