EasyManuals Logo
Home>Roland>Synthesizer>FA-06

Roland FA-06 Parameter Guide

Roland FA-06
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
111
MFX Parameters
54: GuitarAmpSim g Flanger
L in
R in
Flanger
Pre Amp
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
Speaker
Parameter Value Explanation
Pre Amp Sw OFF, ON Turns the amp switch on/o.
Pre Amp Type
Type of guitar
amp
JC-120, CLEAN TWIN, MATCH DRIVE,
BG LEAD, MS1959I, MS1959II,
MS1959I+II, SLDN LEAD, METAL5150,
METAL LEAD, OD-1, OD-2, TURBO,
DISTORTION, FUZZ
Pre Amp Volume
#
0–127
Volume and amount of distortion of
the amp
Pre Amp Master
#
0–127 Volume of the entire pre-amp
Pre Amp Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Pre Amp Bass
0–127
Tone of the bass/mid/treble frequency
range
* Middle cannot be set if “Match
Drive” is selected as the Pre Amp
Type.
Pre Amp Middle
Pre Amp Treble
Flanger Switch # OFF, ON Flanger on/o
Flanger Pre
Delay
0.0–100.0 ms
Adjusts the delay time from when the
direct sound begins until the anger
sound is heard.
Flanger Rate
(Hz) #
0.05–10.00 Hz Frequency of modulation
Flanger Depth # 0–127 Depth of modulation
Flanger
Feedback #
-98–+98 %
Adjusts the proportion of the anger
sound that is fed back into the eect.
Negative (-) value will invert the
phase.
Flanger Balance
#
D100:0W–
D0:100W
Adjusts the volume balance between
the sound that is sent through the
anger (W) and the sound that is not
sent through the anger (D).
Speaker Sw OFF, ON
Selects whether the sound will be sent
through the speaker simulation (ON)
or not (OFF)
Speaker Type
(See the
following table)
Type of speaker
Level 0–127 Output Level
Specications of each Speaker Type
The speaker column indicates the diameter of each speaker unit (in
inches) and the number of units.
Type Cabinet Speaker Microphone
SMALL 1 small open-back enclosure 10 dynamic
SMALL 2 small open-back enclosure 10 dynamic
MIDDLE open back enclosure 12 x 1 dynamic
JC-120 open back enclosure 12 x 2 dynamic
BUILT-IN 1 open back enclosure 12 x 2 dynamic
BUILT-IN 2 open back enclosure 12 x 2 condenser
BUILT-IN 3 open back enclosure 12 x 2 condenser
BUILT-IN 4 open back enclosure 12 x 2 condenser
BUILT-IN 5 open back enclosure 12 x 2 condenser
BG STACK 1 sealed enclosure 12 x 2 condenser
BG STACK 2 large sealed enclosure 12 x 2 condenser
Type Cabinet Speaker Microphone
MS STACK 1 large sealed enclosure 12 x 4 condenser
MS STACK 2 large sealed enclosure 12 x 4 condenser
METAL STACK large double stack 12 x 4 condenser
2-STACK large double stack 12 x 4 condenser
3-STACK large triple stack 12 x 4 condenser
55: GuitarAmpSim g Phaser
L in
R in
L out
R out
Pre
Amp
Speaker
Phaser
Resonance
Mix
Parameter Value Explanation
Pre Amp Sw OFF, ON Turns the amp switch on/o.
Pre Amp Type
Type of guitar
amp
JC-120, CLEAN TWIN, MATCH DRIVE,
BG LEAD, MS1959I, MS1959II,
MS1959I+II, SLDN LEAD, METAL5150,
METAL LEAD, OD-1, OD-2, TURBO,
DISTORTION, FUZZ
Pre Amp Volume
#
0–127
Volume and amount of distortion of
the amp
Pre Amp Master
#
0–127 Volume of the entire pre-amp
Pre Amp Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Pre Amp Bass
0–127
Tone of the bass/mid/treble frequency
range
* Middle cannot be set if “Match
Drive” is selected as the Pre Amp
Type.
Pre Amp Middle
Pre Amp Treble
Phaser Switch # OFF, ON Phaser on/o
Phaser Manual # 0–127
Center frequency at which the sound
is modulated
Phaser
Resonance #
0–127 Amount of feedback
Phaser Mix # 0–127 Volume of phase-shifted sound
Phaser Rate
(Hz) #
0.05–10.00 Hz Modulation rate
Phaser Depth # 0–127 Modulation depth
Speaker Sw OFF, ON
Selects whether the sound will be sent
through the speaker simulation (ON)
or not (OFF)
Speaker Type
(See the
following table)
Type of speaker
Level 0–127 Output Level

Table of Contents

Other manuals for Roland FA-06

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roland FA-06 and is the answer not in the manual?

Roland FA-06 Specifications

General IconGeneral
Control typeButtons
Backlight colorRed
Backlight buttonsYes
MIDI-keyboard number of keys61 keys
Display typeLCD
Display diagonal5 \
Product colorBlack
Sound effectsAcoustic resonance, Synthesizer
InterfaceUSB
Headphone outputs1
USB ports quantity2
Compatible memory cardsSDHC
6.35 mm (1⁄4-inch) output3
Power source typeAC
Bit rate16 bit
Product typeDigital synthesizer
Keyboard number of keys61
Maximum polyphony (notes)128
Reverberation effects quantity6
Weight and Dimensions IconWeight and Dimensions
Depth300 mm
Width1008 mm
Height101 mm
Weight5700 g

Related product manuals