Roland FA-06 Parameter Guide

IFX Parameters
81
Specications for each Speaker Type
The speaker column indicates the diameter of each speaker unit (in
inches) and the number of units.
Type Cabinet Speaker Microphone
SMALL 1 Small open-back enclosure 10 Dynamic
SMALL 2 Small open-back enclosure 10 Dynamic
MIDDLE Open back enclosure 12 x 1 Dynamic
JC-120 Open back enclosure 12 x 2 Dynamic
BUILT-IN 1 Open back enclosure 12 x 2 Dynamic
BUILT-IN 2 Open back enclosure 12 x 2 Condenser
BUILT-IN 3 Open back enclosure 12 x 2 Condenser
BUILT-IN 4 Open back enclosure 12 x 2 Condenser
BUILT-IN 5 Open back enclosure 12 x 2 Condenser
BG STACK 1 Sealed enclosure 12 x 2 Condenser
BG STACK 2 Large sealed enclosure 12 x 2 Condenser
MS STACK 1 Large sealed enclosure 12 x 4 Condenser
MS STACK 2 Large sealed enclosure 12 x 4 Condenser
METAL STACK Large double stack 12 x 4 Condenser
2-STACK Large double stack 12 x 4 Condenser
3-STACK Large triple stack 12 x 4 Condenser
40: Compressor
Flattens out high levels and boosts low levels, smoothing out
uctuations in volume.
L in
R in
L out
R out
Compressor
2-Band EQ
2-Band EQ
Compressor
Parameter Value Explanation
Attack 0–127
Sets the time from when the input
exceeds the Threshold until the
volume starts being compressed
Threshold 0–127
Adjusts the volume at which
compression begins
Post Gain 0–+18 dB Adjusts the output gain.
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Level 0–127 Output Level
41: Limiter
Compresses signals that exceed a specied volume level, preventing
distortion from occurring.
L in
R in
L out
R out
Limiter
2-Band EQ
2-Band EQ
Limiter
Parameter Value Explanation
Release 0–127
Adjusts the time after the signal
volume falls below the Threshold
Level until compression is no longer
applied.
Threshold 0–127
Adjusts the volume at which
compression begins
Ratio
1.5:1, 2:1, 4:1,
100:1
Compression ratio
Post Gain 0–+18 dB Adjusts the output gain.
Low Gain -15–+15 dB Gain of the low range
Parameter Value Explanation
High Gain -15–+15 dB Gain of the high range
Level 0–127 Output Level
42: Gate
Cuts the reverb’s delay according to the volume of the sound
sent into the eect. Use this when you want to create an articial-
sounding decrease in the reverb’s decay.
L in
R in
L out
R out
Gate
Gate
Parameter Value Explanation
Threshold 0–127
Volume level at which the gate begins
to close
Mode
Type of gate
GATE
The gate will close when the volume
of the original sound decreases,
cutting the original sound.
DUCK (Ducking)
The gate will close when the volume
of the original sound increases,
cutting the original sound.
Attack 0–127
Adjusts the time it takes for the gate
to fully open after being triggered.
Hold 0–127
Adjusts the time it takes for the gate
to start closing after the source sound
falls beneath the Threshold.
Release 0–127
Adjusts the time it takes the gate to
fully close after the hold time.
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the eect sound (W)
Level 0–127 Output Level
43: Delay
This is a stereo delay.
When Feedback Mode is NORMAL:
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay
When Feedback Mode is CROSS:
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay

Roland FA-06 Specifications

General

Control type	Buttons
Backlight color	Red
Backlight buttons	Yes
MIDI-keyboard number of keys	61 keys
Display type	LCD
Display diagonal	5 \
Product color	Black
Sound effects	Acoustic resonance, Synthesizer
Interface	USB
Headphone outputs	1
USB ports quantity	2
Compatible memory cards	SDHC
6.35 mm (1⁄4-inch) output	3
Power source type	AC
Bit rate	16 bit
Product type	Digital synthesizer
Keyboard number of keys	61
Maximum polyphony (notes)	128
Reverberation effects quantity	6

Weight and Dimensions

Depth	300 mm
Width	1008 mm
Height	101 mm
Weight	5700 g