113
MFX Parameters
57: EP AmpSim g Tremolo
R in
L out
R out
Speaker TremoloEP Amp
Parameter Value Explanation
Type
OLDCASE,
NEWCASE,
WURLY
Type of amp
OLDCASE: a standard electric piano
sound of the early 70s
NEWCASE: a standard electric piano
sound of the late 70s and early 80s
WURLY: a standard electric piano
sound of the 60s
Bass # -50–+50 Amount of low-frequency boost/cut
Treble # -50–+50 Amount of high-frequency boost/cut
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127 Overdrive input level
OD Drive 0–127 Degree of distortion
Tremolo Switch # OFF, ON Tremolo on/o
Tremolo Rate #
0.05–10.00 Hz,
note
Rate of the tremolo eect
Tremolo Depth # 0–127 Depth of the tremolo eect
Tremolo Duty -10–+10
Adjusts the duty cycle of the LFO
waveform used to apply tremolo.
Speaker Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
Level 0–127 Output Level
58: EP AmpSim g Chorus
L in
R in
L out
R out
Speaker ChorusEP Amp
Balance W
Balance W
Balance D
Parameter Value Explanation
Type
OLDCASE,
NEWCASE,
WURLY
Type of amp
OLDCASE: a standard electric piano
sound of the early 70s
NEWCASE: a standard electric piano
sound of the late 70s and early 80s
WURLY: a standard electric piano
sound of the 60s
Bass # -50–+50 Amount of low-frequency boost/cut
Treble # -50–+50 Amount of high-frequency boost/cut
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127 Overdrive input level
OD Drive 0–127 Degree of distortion
Chorus Switch # OFF, ON Chorus on/o
Chorus Pre Delay 0.0–100.0 ms
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Chorus Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Chorus Depth # 0–127 Depth of modulation
Chorus Balance #
D100:0W–
D0:100W
Volume balance of the sound that
passes through the chorus (W) and
the unprocessed sound (D)
Parameter Value Explanation
Speaker Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
Level 0–127 Output Level
59: EP AmpSim g Flanger
L in
R in
L out
R out
SpeakerEP Amp
Balance W
Balance W
Balance D
Balance D
Feedback
Flanger
Parameter Value Explanation
Type
OLDCASE,
NEWCASE,
WURLY
Type of amp
OLDCASE: a standard electric piano
sound of the early 70s
NEWCASE: a standard electric piano
sound of the late 70s and early 80s
WURLY: a standard electric piano
sound of the 60s
Bass # -50–+50 Amount of low-frequency boost/cut
Treble # -50–+50 Amount of high-frequency boost/cut
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127 Overdrive input level
OD Drive 0–127 Degree of distortion
Flanger Switch # OFF, ON Flanger on/o
Flanger Pre
Delay
0.0–100.0 ms
Adjusts the delay time from when the
direct sound begins until the anger
sound is heard.
Flanger Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Flanger Depth # 0–127 Depth of modulation
Flanger
Feedback #
-98–+98 %
Adjusts the proportion of the anger
sound that is fed back into the eect.
Negative (-) value will invert the
phase.
Flanger Balance
#
D100:0W–
D0:100W
Adjusts the volume balance between
the sound that is sent through the
anger (W) and the sound that is not
sent through the anger (D).
Speaker Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
Level 0–127 Output Level