Roland FA-06 Parameter Guide

Studio Set
8
Parameter Value Explanation
D-Beam Assign
CUTOFF Adjusts the cuto frequency.
RESONANCE Adjusts the resonance.
ATTACK Adjusts the attack.
RELEASE Adjusts the release.
PAN Adjusts the pan.
LEVEL Adjusts the volume.
EQ LOW Adjusts the low frequency range.
EQ MID1 Adjusts the mid-1 frequency range.
EQ MID2 Adjusts the mid-2 frequency range.
EQ MID3 Adjusts the mid-3 frequency range.
EQ HIGH Adjusts the high frequency range.
INPUT LEVEL Adjusts the input volume from the AUDIO INPUT jack.
KNOB ASSIGN1–6 Adjust the [1] (ASSIGN 1)–[6] (ASSIGN 6) knobs.
COMPRESSOR Adjusts the compressor.
TONE Adjusts the tone.
CHORUS Adjusts the chorus.
REVERB Adjusts the reverb.
TFX SELECT Selects the total eect.
TFX CTRL Controls the total eect.
SAMPLE PAD Plays a sample.
Range Max 0–127
Species the upper limit of the D-BEAM controller range.
* This is shown only if D-Beam Assign is set to “CC,” “BEND DOWN,” “BEND UP,” or
“AFTERTOUCH.”
MEMO
By setting the Range Max below the Range Min, you can invert the range of variation.
Range Min 0–127
Species the lower limit of the D-BEAM controller range.
* This is shown only if D-Beam Assign is set to “CC,” “BEND DOWN,” “BEND UP,” or
“AFTERTOUCH.”
Beam Assign Knob Polarity STANDARD, REVERSE
STANDARD: The assigned parameter changes in the positive (+) direction when you move your
hand closer to the D-BEAM controller.
REVERSE: The assigned parameter changes in the negative (-) direction when you move your hand
closer to the D-BEAM controller.
* This is shown only if D-Beam Assign is set to “CUTOFF”–”TFX CTRL.”
Beam Assign Sample Pad Number
1-1–4-16
(“Bank-Number” of the sample)
Selects the sample that plays if D-Beam Assign is set to “SAMPLE PAD.”
Control Sw tab
Bend (Control Bender)
OFF, ON
For each controller, these settings specify whether MIDI messages are (ON) or are not (OFF) be
transmitted to the part.
Mod (Control Modulation)
Hold (Control Hold Pedal)
Pedal1 (Control Pedal 1)
Pedal2 (Control Pedal 2)
D-Beam (Control DBeam)
S1 (Control S1)
S2 (Control S2)

Roland FA-06 Specifications

General

Control type	Buttons
Backlight color	Red
Backlight buttons	Yes
MIDI-keyboard number of keys	61 keys
Display type	LCD
Display diagonal	5 \
Product color	Black
Sound effects	Acoustic resonance, Synthesizer
Interface	USB
Headphone outputs	1
USB ports quantity	2
Compatible memory cards	SDHC
6.35 mm (1⁄4-inch) output	3
Power source type	AC
Bit rate	16 bit
Product type	Digital synthesizer
Keyboard number of keys	61
Maximum polyphony (notes)	128
Reverberation effects quantity	6

Weight and Dimensions

Depth	300 mm
Width	1008 mm
Height	101 mm
Weight	5700 g