IFX Parameters
80
Parameter Value Explanation
High Feedback -98–+98 %
Proportion of the high-range anger
sound that is to be returned to the
input (negative (-) values invert the
phase)
High Step Rate
0.10–20.00 Hz,
note
Rate at which the steps will cycle for
the high-range anger sound
Balance
D100:0W–
D0:100W
Volume balance of the original sound
(D) and anger sound (W)
Level 0–127 Output Level
35: Overdrive
Creates a soft distortion similar to that produced by vacuum tube
ampliers.
Amp
Simulator
2-Band
EQ
R in
Over
drive
R out
Pan R
Pan L
Parameter Value Explanation
Drive 0–127
Degree of distortion
Also changes the volume.
Amp Type
Type of guitar amp
SMALL Small amp
BUILT-IN Single-unit type amp
2-STACK Large double stack amp
3-STACK Large triple stack amp
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level
36: Distortion
Produces a more intense distortion than Overdrive. The parameters
are the same as for “35: Overdrive.”
R in
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion
37: VS Overdrive
This is an overdrive that provides heavy distortion.
R in
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Overdrive
Parameter Value Explanation
Drive 0–127
Degree of distortion
Also changes the volume.
Tone 0–127 Sound quality of the Overdrive eect
Amp Sw OFF, ON Turns the Amp Simulator on/o.
Amp Type
Type of guitar amp
SMALL Small amp
BUILT-IN Single-unit type amp
2-STACK Large double stack amp
3-STACK Large triple stack amp
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level
38: VS Distortion
This is a distortion eect that provides heavy distortion. The
parameters are the same as for “37: VS Overdrive.”
R in
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion
39: Guitar Amp Simulator
This is an eect that simulates the sound of a guitar amplier.
R in
R out
Pan R
Pan L
Pre Amp
Speaker
Parameter Value Explanation
Pre Amp Sw OFF, ON Turns the amp switch on/o.
Pre Amp Type
JC-120,
CLEAN TWIN,
MATCH DRIVE,
BG LEAD,
MS1959I,
MS1959II,
MS1959I+II,
SLDN LEAD,
METAL 5150,
METAL LEAD,
OD-1,
OD-2 TURBO,
DISTORTION,
FUZZ
Type of guitar amp
Pre Amp Volume 0–127
Volume and amount of distortion of
the amp
Pre Amp Master 0–127 Volume of the entire pre-amp
Pre Amp Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Pre Amp Bass
0–127
Tone of the bass/mid/treble frequency
range
Middle cannot be set if “MATCH
DRIVE” is selected as the Pre Amp
Type.
Pre Amp Middle
Pre Amp Treble
Pre Amp
Presence
0–127
Tone for the ultra-high frequency
range
Pre Amp Bright OFF, ON
Turning this “On” produces a sharper
and brighter sound.
This parameter applies to the
“JC-120,” “CLEAN TWIN,” and “BG
LEAD” Pre Amp Types.
Speaker Sw OFF, ON
Determines whether the signal passes
through the speaker (ON), or not
(OFF).
Speaker Type
(See the
following table)
Type of speaker
Mic Setting 1, 2, 3
Adjusts the location of the
microphone that’s capturing the
sound of the speaker.
This can be adjusted in three steps,
from 1 to 3, with the microphone
becoming more distant as the value
increases.
Mic Level 0–127 Volume of the microphone
Direct Level 0–127 Volume of the direct sound
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level