Roland FA-06 Parameter Guide

SuperNATURAL Synth Tone (SN-S)
37
Parameter Value Explanation
Envelope Loop Sync Note *1 Note (p. 116)
Returns to the Attack at the specied rate. If the Attack+Decay time is shorter than the specied
rate, the Sustain Level will be maintained. If the Attack+Decay time is longer than the specied
rate, the envelope will return to the Attack even though the Decay has not been completed.
This will continue repeating until note-o occurs.
Chromatic Portamento *1 OFF, ON If this is turned on, portamento will operate in semitone steps.
MFX tab
MFX Sw
([2] (MFX Sw) button)
OFF, ON Species whether the tone’s multi-eect is used (ON) or not used (OFF).
MFX Type 0–68
Use this parameter to select from among the 68 available multi-eects.
For details on multi-eects parameters, refer to “MFX Parameters” (p. 93).
Parameters for each MFX type Edit the parameters for the selected MFX type.
MFX Chorus Send Level 0–127
Adjusts the amount of chorus for the sound that passes through multi-eects. If you don’t want to
add the chorus eect, set it to “0.”
MFX Reverb Send Level 0–127
Adjusts the amount of reverb for the sound that passes through multi-eects. If you don’t want to
add the reverb eect, set it to “0.”
MFX Control tab
Source (1–4)
OFF,
CC01–31,
33–95,
PITCH BEND,
AFTERTOUCH,
SYS CTRL1–4
Sets the MIDI message used to change the multi-eects parameter with the multi-eects control.
OFF: Multi-eects control will not be used.
CC01–31, 33–95: Control Change
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS CTRL1–4: MIDI messages used as common multi-eects controls.
Destination (1–4)
Sets the multi-eects parameters to be controlled with the multi-eects control. The multi-eects parameters available for control will
depend on the multi-eects type. For details, refer to “Controlling a MFX via MIDI (MFX CONTROL)” (p. 117).
Sens (1–4) -63–+63
Sets the amount of the multi-eects control’s eect that is applied. To make an increase in the
currently selected value (to get higher values, move to the right, increase rates, and so on), select a
positive (+) value; to make a decrease in the currently selected value (to get lower values, move to
the left, decrease rates, and so on), select a negative (-) value. For either positive or negative value,
greater absolute values will allow greater amounts of change. Set this to “0” if you don’t want to
apply the eect.

Roland FA-06 Specifications

General

Control type	Buttons
Backlight color	Red
Backlight buttons	Yes
MIDI-keyboard number of keys	61 keys
Display type	LCD
Display diagonal	5 \
Product color	Black
Sound effects	Acoustic resonance, Synthesizer
Interface	USB
Headphone outputs	1
USB ports quantity	2
Compatible memory cards	SDHC
6.35 mm (1⁄4-inch) output	3
Power source type	AC
Bit rate	16 bit
Product type	Digital synthesizer
Keyboard number of keys	61
Maximum polyphony (notes)	128
Reverberation effects quantity	6

Weight and Dimensions

Depth	300 mm
Width	1008 mm
Height	101 mm
Weight	5700 g