SuperNATURAL Acoustic Tone (SN-A)
30
Parameter Value Explanation
MFX tab
MFX Sw
([2] (MFX Sw) button)
OFF, ON Species whether the tone’s multi-eect is used (ON) or not used (OFF).
MFX Type 0–68
Use this parameter to select from among the 68 available multi-eects. For details on multi-eects
parameters, refer to “MFX Parameters” (p. 93).
Parameters for each MFX type Edit the parameters for the selected MFX type.
MFX Chorus Send Level 0–127
Adjusts the amount of chorus for the sound that passes through multi-eects. If you don’t want to
add the chorus eect, set it to “0.”
MFX Reverb Send Level 0–127
Adjusts the amount of reverb for the sound that passes through multi-eects. If you don’t want to
add the reverb eect, set it to “0.”
MFX Control tab
Source (1–4)
OFF,
CC01–31,
33–95,
PITCH BEND,
AFTERTOUCH,
SYS CTRL1–4
Sets the MIDI message used to change the multi-eects parameter with the multi-eects control.
OFF: Multi-eects control will not be used.
CC01–31, 33–95: Control Change
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS CTRL1–4: MIDI messages used as common multi-eects controls.
Destination (1–4)
Sets the multi-eects parameters to be controlled with the multi-eects control. The multi-eects parameters available for control will
depend on the multi-eects type. For details, refer to “Controlling a MFX via MIDI (MFX CONTROL)” (p. 117).
Sens (1–4) -63–+63
Sets the amount of the multi-eects control’s eect that is applied.
To make an increase in the currently selected value (to get higher values, move to the right,
increase rates, and so on), select a positive (+) value; to make a decrease in the currently selected
value (to get lower values, move to the left, decrease rates, and so on), select a negative (-) value.
For either positive or negative value, greater absolute values will allow greater amounts of change.
Set this to “0” if you don’t want to apply the eect.