116
Appendix
Appendix
Error message list
Message
Explanation
xxx is used for EXT FXx
Do you want to disable it?
Port xxx is being used by EXT FXx. Do you want to disable EXT FXx?
Cannot operate the USB memory.
It exceeds the power capability.
The device connected to the USB MEMORY connector used more than the maximum allowable electrical current.
Internal battery is low. The internal lithium battery has run down.
Internal data were damaged.
M-200i starts with initialized setting.
Data was initialized because the internal memory data was lost when the internal lithium battery was depleted
or was replaced.
Media is abnormal. The USB memory has malfunctioned.
Media not formatted. The USB memory has not been formatted.
MIDI/RS-232C Rx Error
Framing.
An inappropriate signal is being input to MIDI/RS-232C.
MIDI/RS-232C Rx Error
Buffer Full.
Too much data is being received via MIDI/RS-232C.
REAC Error
Fan Stop.
The cooling fan of the input/output unit connected to REAC has stopped.
REAC Error
Temp High.
The temperature of the input/output unit connected to REAC has become abnormally high.
REAC : Wrong sampling frequency. A REAC device whose sampling frequency is not supported by the M-200i is connected to REAC.
The data is locked You attempted to edit a locked scene or library item.
The internal FAN has stopped. The cooling fan located on the bottom panel has stopped.
USB MIDI Rx Error
Buffer Full.
Too much data is being received via USB MIDI.
LAN Rx Error
Buffer Full.
Too much data was received by the LAN function.
Could not make the wireless
connection.
A connection cannot be established.
Troubleshooting (p. 117)
This Access point is not supported.
The access point is unsupported. Use WPS or WPS2 as the authorization scheme.
WIRELESS LAN Rx Error
Buffer Full.
Too much data was received by the WIRELESS LAN function.
DOCK Rx Error
Buffer Full.
Too much data was received via the DOCK CABLE connector.
M-200i_e.book 116 ページ ２０１３年１月１６日 水曜日 午後４時９分
To Next Page
Loading...
Need help?
General
