59
Metering
Metering
This section describes the METER screen, where you can view a
list of channel levels.
1.
In the top panel's DISPLAY section, press [METER].
fig.ScrMeter.eps
The METER screen is displayed.
You can view a list of the levels of the channels.
To change the level detection point of the meter and make peak
hold settings, you use the METER FUNCTION screen.
1.
Access the METER screen.
2.
Press [FUNC] to access the METER FUNCTION screen.
The functions available at the METER FUNCTION screen are as
follows:
For information on PEAK CLEAR, go to “Basic operation,“ and
refer to “Peak clear“ (p. 33).
For information on HOME SCREEN, go to “User preferences ,“
and refer to “Selecting the Home screen” (p. 95).
About the meters
Accessing the METER screen
METER FUNCTION screen
PEAK HOLD
This turns the meter's peak hold function on/off.
PEAK HOLD TIME This sets the duration that the meter's peak hold or
OVER indication stays lighted, in a range of 1 sec to 4
sec or CONTINUE. Meter peak hold is enabled only
when the PEAK HOLD is on.
OVER LEVEL This adjusts the level at which the OVER indication of
the meter lights up, in a range of -18 dB to 0 dB.
CH METERING
POINT
Use these to select the level detection point for the
CH meters.
BUS METERING
POINT
Use these to set the level detection point for the
AUX/MTX/MAIN meters.
HOME
SCREEN
Selects the unit's Home screen.
PEAK CLEAR Clears the level meter's peak hold or over indication.
M-200i_e.book 59 ページ ２０１３年１月１６日 水曜日 午後４時９分
To Next Page
Loading...
Need help?
General
